The spring actuated machine needle shut-off nozzle s type A(S) are used in processing of thermoplastics , principally with low viscosity materials such as: PA, PPS, PE, POM, PP. Finds application in:
Packaging, automobile and leisure industries, medicinal and electronic equipment. Operation:
The nozzle is opened directly from the injection pressure and closed again with spring power. A needle which moves axially in the needle shut-off nozzle is held in the closed position by the force of the spring. The nozzle orifice is normally closed. With the increasing melt pressure exerted against the spring through a ring of exposed surface area on the needle, the nozzle opens at 200 bar . If the melt pressure drops (below 80bar), the nozzle closes. - If the standard opening pressure is not appropriate, the needle must be modified to the requirements (modification of the spring is not possible).
- A temperature resistant material (bis max. 520°C) is used for the spring construction.
- The nozzle size required depends on the injection rate per second (cm3/s). Prevents:
• Stringing, drooling
• Air pockets during screw retraction
• Material leakage when dosing with a withdrawn injection unit
• Material leakage while vertically injecting Productivity factors:
• Controlled, clean shut-off of the melt stream
• Shorter cycle times - increase in productivity
• Increased process reliability and repeatability
• Usability with increased back pressure - improved homogenization
• Quick machine installation
• Add-on capability (on tool side) Option:
• Filter module | 
